Kit Contents
- 4 Recess Bumper Fit Sensors
- 1 Control Unit
- LED Display & Audio Buzzer Unit
- 1 Cutting Tool FREE!
- 1 Wiring Harness
- Fitting Accessories
How it works
The system works by radiating ultrasonic beams covering the area behind the vehicle. The beams are reflected by obstructions behind the vehicle, and re-enter the sensors. The reflected beam information is processed to calculate the distance of the obstruction.
As with the other systems the Veba's are activated when reverse gear is engaged. As the vehicle is reversed. When the vehicle is less than 1.5 metres from the obstruction the audible alert will emit intermittent bleeps. As the vehicle gets closer to the obstruction the display indicates the reduction in distance and the frequency of the bleeps increases. At 45 centimetres from the obstruction the bleeps become a continuous solid tone.
|
 |
The Veba recess systems can also be attached to the front of a vehicle for all-round protection. In this instance the power lead needs to be wired into the fuse box rather than the reversing light so that power is always on when the car is in ignition. We suggest the fuse for the car stereo or interior lights.
Optional Wedge Included
This system comes with an optional wedge, giving greater flexibility according to the shape of your bumper. The wedge can be used if your bumper is slightly angled up- or downwards, to ensure the sensor's signal is still sent out parallel with the road's surface. If your bumper is vertical, then the wedge can be removed to flush-mount the sensors instead. See pictures below.
Technical Specification
- Specified voltage DC12V/24V
- Operating temperature -25°C ~ 80°C
- Storage temperature -30°C ~ 85°C
- Operating frequency 40KHz ± 2KHz
- Detection angle 120° Horizontal 60° Vertical
- Detection method Ultrasonic wave
Some Useful Measurement Information
(measurements are approximate and not guaranteed) |
| Component |
Length x Width x Depth |
Size of LED / Buzzer
Screen (Arced) |
77mm x 30mm x 20mm
65mm x 15mm |
| Size of Processor |
127mm x 74mm x 23mm |
| Size of Ultrasonic Recess Sensors |
21mm Dia. 20mm deep |
| Diameter Size For Drilling |
21mm (Drill Bit Supplied) |
| Length of Sensors Cabling |
2.5m |
| Length of Cabling for Buzzer |
5m |
Maintenance
No routine maintenance or adjustment is required. Dirt, frost or snow accumulated on the sensors may cause the system to activate incorrectly. Clean carefully with a soft cloth. Do not use chemicals or spirits. Applying hot water in frozen conditions may damage the sensors. The sensors can be washed carefully with warm soapy water.
