Contents

• Four bumper fit sensors
• Warning buzzer
• LED display
• Control unit
• Cutting tool
• Wiring harness
• Fixing accessories
• TFT mirror

How it works
The system works by radiating ultrasonic beams covering the area behind the vehicle. The beams are reflected by obstructions behind the vehicle, and re-enter the sensors. The reflected beam information is processed to calculate the distance of the obstruction.

As with the other systems the Veba's are activated when reverse gear is engaged. As the vehicle is reversed. When the vehicle is less than 1.5 metres from the obstruction the audible alert will emit intermittent bleeps. As the vehicle gets closer to the obstruction the display indicates the reduction in distance and the frequency of the bleeps increases. At 45 centimetres from the obstruction the bleeps become a continuous solid tone.

The Veba recess systems can also be attached to the front of a vehicle for all-round protection. In this instance the power lead needs to be wired into the fuse box rather than the reversing light so that power is always on when the car is in ignition. We suggest the fuse for the car stereo or interior lights.

Technical Specification

• Rated Voltage (range) - 12V(10.5V~16V DC)
• Rated Current - 200mA~600mA
• Detection Distance - 0.2m~1.5m
• Camera Viewing Angle - 90⁰
• Sensor Frequency - 40KHz
• Working Temperature of Control Box - -30~+80

Some Useful Measurement Information (measurements are approximate and not guaranteed)
Component	Length x Width x Depth
Size of Control Box	12 x 9.4 x 2.7cm
Size of Speaker	7.4 x 5 x 2cm
Size of Ultrasonic Recess Sensors	21mm Dia. 20mm deep
Size of Camera	25mm Dia. 40mm deep
Size of Screen	26 x 8.6 x 2.5
Diameter Size For Sensor Drilling	21mm (Drill Bit Supplied)
Diameter Size For Camera Drilling	25mm (Drill Bit Supplied)
Length of Speaker Cable	5m
Length of Sensors Cabling	2.5m

Maintenance
No routine maintenance or adjustment is required. Dirt, frost or snow accumulated on the sensors may cause the system to activate incorrectly. Clean carefully with a soft cloth. Do not use chemicals or spirits. Applying hot water in frozen conditions may damage the sensors. The sensors can be washed carefully with warm soapy water.