Kit Contents

• 1 Adhesive Bumper Fit Sensor Strip
• 1 Control Unit
• Audio Buzzer Unit
• 1 Cutting Tool FREE!
• Fitting Accessories

How it works
The system works by radiating ultrasonic beams covering the area behind the vehicle. The beams are reflected by obstructions behind the vehicle, and re-enter the sensors. The reflected beam information is processed to calculate the distance of the obstruction.

As with the other systems the Veba's are activated when reverse gear is engaged. As the vehicle is reversed. When the vehicle is less than 1.5 metres from the obstruction the audible alert will emit intermittent bleeps. As the vehicle gets closer to the obstruction the display indicates the reduction in distance and the frequency of the bleeps increases. At 45 centimetres from the obstruction the bleeps become a continuous solid tone.

The Veba AVRSNP system can also be attached to the front of a vehicle for all-round protection. In this instance the power lead needs to be wired into the fuse box rather than the reversing light so that power is always on when the car is in ignition. We suggest the fuse for the car stereo or interior lights.

Technical Specification

• Rated voltage (range) 12V(10.5~16V DC)
• Rated Current 20mA~200mA
• Detection Distance 0.2~1.5m
• Sensor Frequency 40KHz
• Working temperature of control box -30 ~+70
  

Some Useful Measurement Information (measurements are approximate and not guaranteed)
Component	Length x Width x Depth
Size of Buzzer	73mm x 49mm x 18mm
Size of Processor	95mm x 76mm x 26mm
Size of Ultrasonic Sensor Strip	520mm x 28mm x 23mm
Length of Sensor Strip Cabling	50cm
Length of Cabling for Buzzer	2.5m

Maintenance
No routine maintenance or adjustment is required. Dirt, frost or snow accumulated on the sensors may cause the system to activate incorrectly. Clean carefully with a soft cloth. Do not use chemicals or spirits. Applying hot water in frozen conditions may damage the sensors. The sensors can be washed carefully with warm soapy water.